The working principle of vertical cyclone separator is to use the induced draft fan for air volume transport so that the dust-bearing gas enters the box through the inlet of the dust collector. The dust-bearing gas is filtered through the filter bag through the gas shunt. The dust is left on the inner surface of the filter bag, and the purified gas enters the induced draft fan through the filter bag and is discharged by the exhaust pipe. After the dust collector works for a period of time, the dust on the filter bag gradually increases the resistance of the dust filter bag, and the dust collector needs to be cleaned, and the dust collector works normally after the cleaning is completed. With the increase of filtration time, the filter bag residual adsorbed dust more and more and affect the normal dust removal work, using the shutdown since shaking vibration for tens of seconds, so that the residual dust attached to the internal surface of the filter bag shake down, dust into the ash bucket, drawer or directly onto the conveyor belt.

Below, take you to understand the design concept of vertical cyclone separator:

First, the use of encapsulation type polyester felt flat cloth bag, good service life.

Second, the application of computer-aided design software, CNC processing equipment, mold production, to the modular structure, can be arbitrarily combined the number of layers and columns.

3. The filter bag is changed outside the inspection door in front of the modular flat bag dust collector to prevent dust from entering the clean air chamber, which is easy to operate and maintain.

Fourth, flexible inlet and outlet design, can achieve complex and changeable installation sites.

Five, modular flat bag dust filter more than 0.003um dust, special configuration can reach 0.3mg/m3 below the emission requirements, the dust collector noise is less than 80dB.

6. The modular flat bag dust collector is designed for submerged flow, which reduces the influence of turbulence caused by dust and saves electricity and energy.

vertical cyclone separator should open the inspection door every week to check whether the dust bag is normal, whether the surface area powder is too much, and find the cause and eliminate the fault. If the fault is found, it should be stopped in time, find the cause, and then use it after repair. The equipment should keep the pulse controller surface clean. The pulse dust collector needs to add LC-250 high drop point synthetic grease to the air pump bearing once every 1000 hours of work, and replace the grease once a year. During the use of the equipment, the air pump filter is cleaned once every half month to ensure that the gas path is smooth. The pulse dust collector often checks the grease of the fuel tank of the fan reducer motor and makes it up in time. The pulse dust collector checks the large film in the pulse valve 1-2 times a year, and the damaged and aging ones should be replaced in time.

vertical cyclone separator https://www.kaisenfilter.com/Cyclone-Separators.html